Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Using go/no-go tool in crimp tool

Status
Not open for further replies.

engr_joni_ee

Advanced Member level 3
Joined
Nov 3, 2018
Messages
707
Helped
2
Reputation
4
Reaction score
3
Trophy points
18
Activity points
5,822
Hi, I am working with Daniels DMC crimp tool M22520/2-01. It comes with a positioner M22520/2-08 and a go/no-go tool M22520/3-01. In order to perform go/no-go check I have to set the positioner on the crimp tool at a particular position as it only work with one particular selector position. I am just wondering do we have only one go/no-go tool or have several go/no-go tool for each selector position belong to same crimp tool ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top