in my project i am having 8 sensors. the sensors are placed 5 meters apart from the main pic control board. from the sensor to main pic control board i am using this LAN cable. for example if the first sensor is active it will send a logic 24 high through the lan cable this is receiver at the receiver side digital input board (opto-coupler-pc817) based then the signal is converted to 5v and fed to the pic controller io.
my dout is lan cables are ment for differential signal transmission because of twisting pair. in my project i am using the 4 twisted pair that is 8 wires for 8 digital input. can i use LAN cables it is correct? kindly help
Shielded CAT 5 may work but be prone to stray CM fields but opto isolated should give decent CM rejection but some crosstalk between sensors. May need filter cap. ( ~100pf/m ?)
So it depends on noise, speed and crosstalk and resulting SNR.
Might be fine if you verify with stray transient and hum tests.
Shielded CAT 5 may work but be prone to stray CM fields but opto isolated should give decent CM rejection but some crosstalk between sensors. May need filter cap. ( ~100pf/m ?)
So it depends on noise, speed and crosstalk and resulting SNR.
Might be fine if you verify with stray transient and hum tests.