Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Using Brown-out detect Flag Bit

Status
Not open for further replies.
C

cnurettin

Newbie level 4
Joined
Jan 15, 2008
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,314
Hi all,

My circuit resets with two reasons.

1- my circuit resets if i turn off then turn on power

2- my circuit resets if a electirical noise in my power. ( For exapmle: surge )

I want to separate them ( 1 and 2 ).

So i used brown_out detect flag bit.

But when power is on brown out detect flag bit on. So i cant separate 1. state or 2. state .

Can you help me about this subject ?

Best Regards,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top