USB HID - Hardware Profile

[yawijaya]

Hi guys, i have question about USB HID firmware and GUI programming. Just say if I have a completely working software and firmware with one USB pcb board configuration(lets say board A). If i want to use the same software and firmware on another board(board B) with same microcontroller, but different pin configuration on the board, is it true that the only part i need to change is the HardwareProfile.h on the firmware?or is there anything else i need to change too. I'm referring to the USB HID firmware example from Jan Axelson (lvr.com) Thanks!

 

[unaided]

You just need to change pin configuration in your firmware.