iamvineeth
Newbie level 1
- Joined
- Jun 13, 2014
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 8
Hello,
I am trying to develop the USB interface with a PIC18F4550 with the help of a EasyPIC6 Development Board. I am using MPLAB v8.56. After looking through the USB device example (HID Device Custom) on Microchip Libraries for Applications (MLA), I could build the hex file successfully for my project.
Then, I used mikroProg Suite to write the hex file onto the chip.
After it is written successfully, I get a pop up saying "USB device not recognized".
I am attaching the zip package below.
I guess the problem could be with the descriptors. But I am not sure. It would be great if someone can help me out.
Regards,
Vineeth
I am trying to develop the USB interface with a PIC18F4550 with the help of a EasyPIC6 Development Board. I am using MPLAB v8.56. After looking through the USB device example (HID Device Custom) on Microchip Libraries for Applications (MLA), I could build the hex file successfully for my project.
Then, I used mikroProg Suite to write the hex file onto the chip.
After it is written successfully, I get a pop up saying "USB device not recognized".
I am attaching the zip package below.
I guess the problem could be with the descriptors. But I am not sure. It would be great if someone can help me out.
Regards,
Vineeth