nicko-391
Member level 2
I have connected a PIC to PC using USB CDC. CCS was used for firmware & vb.net for software.
Programme properly runs.
My problem is how can software identify which usb port is connected to pic? Now i can not communicate through every usb port because when the cdc driver is installed in the PC, it gives various COM port numbers for each usb port,but in vb programme it should mention specofoc COmport name.
Programme properly runs.
My problem is how can software identify which usb port is connected to pic? Now i can not communicate through every usb port because when the cdc driver is installed in the PC, it gives various COM port numbers for each usb port,but in vb programme it should mention specofoc COmport name.