Hi,
after generating the Gerber files, and talked with my PCB manufacturer, some modifications need to be done.
Once these modifications are done, I re-generate the Gerber files, but here I have the problem.
Gerber files are not updating, they are the same as previous version.
- Steps:
- Update & Check DRC Errors.
- Display Status.
- Create Artwork files. Previously, I have matched etch layers, soldermask_bottom, soldermask_top, silkscreen_bottom, silkscreen_top and borderline, for new design.
- Then, I create a new board and import new Artwork files for checking the Gerbers, but they have no change.
Does any feature on OrCAD I have to modify?
Is there any step I'm missing?
Regards.
- - - Updated - - -
Gerber files are properly created.
The issue comes from PCB Editor which doesn't read the files as it should.
With other Gerber files viewer, all works fine.