Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Unusual problem with atmega8

Status
Not open for further replies.

mishra12

Advanced Member level 2
Advanced Member level 2
Joined
Feb 18, 2009
Messages
672
Helped
136
Reputation
272
Reaction score
122
Trophy points
1,323
Location
some where left alone
Visit site
Activity points
4,915
dear experts
a simple lcd interfacing code ,code was compiled with no errors and verified in proteus .
my circuit
vcc pin7 of atmega8
gnd pin8 of atmega8
internal crystal used
then by mistakely i connected AVCC to gnd
but lcd showed the text message after half mins my atmega8 was very hot ,i removed power supply and AVCC connected to VCC now it does not showed anything what is the problem ?my question is why lcd displayed test message even AVCC connected to the ground ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top