I am laying out an RF board in Altium and I got 75 ohm and 50 ohm traces and proper rules setup for each. The particular trace as shown in the attached picture is a 75 ohm trace which has error markers that does not disappear even when I reset all markers. As you can see the markers are on the pads even when I remove the trace. When I run DRC i get no specific errors.
From the above picture it is not clear what error markers are you referring to. In general primitives with errors are highlighted in different colors from all others. Should we assume that you're considering that the dashed blue region within each G component are error markers, or are you aware that it is just a mechanical layer inherent to the component itself ?
Thanks for your reply. I am talking about the error markers on NetC1_1, you can see them on the trace as well as the component pads as you go along the path. Pads of J2, G1, C1 and L1 are affected with the trace. It is not a mechanical layer of the component.
The only 'error' I see there on NetC1_1 are just missing connections, which is not indeed a rule violation, unless you have configured online DRC as such.