tiwari.sachin
Full Member level 6
I am using PCB Editor 15.7 and have designed a board. When i check the DRC, its showing me that there are 5 DRC Errors, but i am unable to see where these errors are.
In color and visibility --> stack up --> DRC (This option is ON)
Initially it had 6 DRC errors and infact i was able to view 1 point and rectified it, but the remaining 5, i am unable to view.
Are there any other visibility setting that i am missing out.
I have attached the visibility settings that i have done.
In color and visibility --> stack up --> DRC (This option is ON)
Initially it had 6 DRC errors and infact i was able to view 1 point and rectified it, but the remaining 5, i am unable to view.
Are there any other visibility setting that i am missing out.
I have attached the visibility settings that i have done.