sarmad_101
Member level 3
- Joined
- Sep 18, 2008
- Messages
- 56
- Helped
- 1
- Reputation
- 2
- Reaction score
- 1
- Trophy points
- 1,288
- Location
- GERMANY
- Activity points
- 1,658
Hi,
I wanted to send data by microcontroller and FPGA on a single line TX and RX.
TX and RX is connected to the CANBUS transceiver so in this way both the controller behave like a master but only one will interact to the transceiver at a time.
Do I need any pull-up or pull down in my circuit that I made ? I have enclosed the image below.
Thank you.
I wanted to send data by microcontroller and FPGA on a single line TX and RX.
TX and RX is connected to the CANBUS transceiver so in this way both the controller behave like a master but only one will interact to the transceiver at a time.
Do I need any pull-up or pull down in my circuit that I made ? I have enclosed the image below.
Thank you.
