Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Tool for looking PCB files with mistakes marked?

Status
Not open for further replies.

Meklaud

Junior Member level 1
Joined
Apr 19, 2005
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,390
Well the situation is following: When i make a PCB file,I make gerber file after it (no matter if it is Orcad or Protel) and then I send it to a manufacturer.If I have some mistakes they send me a PCB file with mistakes that are marked,but also they have to send me a software so i can see my mistakes. I cannot see them in my ordinary tool(DXP) simply i cannot open that PCb file with mistakes that are visible.is there any software and where to find it to make it possible seeing those files.
 

Meklaud

Junior Member level 1
Joined
Apr 19, 2005
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,390
Now I have found the name of a programme which is used by a PCB manufacturer in budapest.

It is called CAMVu 7.0
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top