As a reminder this is the program that helps you to program the above mentioned microcontrollers through ISP interface, without removing from the target board.
Just use the adapter cable fitted between PC parallel port and the target board.
I have made the cable ISP from ATMEL, by hence software from Atmel ISP program, but fail to, each time inisialisasi always fail, I dont know its cause.
Now, I make ISP programming self and still in progress...
I make the ISP cable (ISP_C_V5) and when i test it today its work. i was try to make it in proto board, but it dont work, so I make it in matrix PCB and its work.
I using windows XP sp1 and I didn't use the buffer(that connect to error pin) because it said that it will work even we dont use it, and that's right ^^. the resistor I use are 68 ohm rather than 100 ohm Thanx.