Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
There are three kinds of probe station :manual, semi auto, and fully auto.
Basically the probe station is used to measure the chip in wafer to take the test key parameter in pure environment say in the vacuity and high temp or low temp in its chamber. It will have less particle.
To take the WAT data use the semi- or fully auto probe station, because it will wast much time to do repeat-action.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.