tetramax manual
hello freinds i am using two commands two open tmax
csh , source /home/student1/synopsys/synopsys.cshrc , tmaxgui ........ after that tool is opening . I have done dc(dft compiler flow ) to my design and generated corresponding design.ddc, .spf(stil file) for the Rtl design in dc.
I have mux for scan dft. I want to know other than these two .ddc, .spf any other output u will have from dc as input to tetramax......
My basic problem is that tmax is not responding to commands which i run on design . ""It is BUILD mode always and there is no response for my commands. .... I am using Solvnet manual with me . The commands are run based on them ...........
Any body tell me whether tmax is in proper condition if correct than tell me proper flow for scan dft in tmax