Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

synopsys, custom designer, HSPICE DC operating point error

Status
Not open for further replies.
A

ali kotb

Member level 3
Member level 3
Joined
Feb 11, 2012
Messages
61
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,732
hello ,
when i need to check the DC operating points of a certain instance on custom designer and HSPICE, it gives me the following warning : " instance '/M31' and parameter 'vds' not found in simulation results, Subsequent warnings on this matter will be suppressed for other instances."

what can i do in order to check the dc operating points ?
 

I didn't write any , i use the GUI version for a complete analog flow
thnx for ur reply
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top