nirmal_rockin
Junior Member level 2
I need to build a h bridge for two motors for which i need a motor driver which can operate at 24v and above 20 Amperes
pls help
thanks....
pls help
thanks....
Welcome to EDAboard.com
Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
suggest a motor driver.... pls help
- Thread starter nirmal_rockin
- Start date
- Status
haker_fox
Member level 3
- Joined
- Jun 24, 2009
- Messages
- 60
- Helped
- 10
- Reputation
- 20
- Reaction score
- 6
- Trophy points
- 1,288
- Location
- Russia, Irkutsk
- Activity points
- 1,556
nirmal_rockin said:
You should go to www.irf.com This is the biggest manufacturer of MOSFETs, IGBTs, drivers for them and etc. There are also good application notes there. Look them. Choose suitable components and drivers according to the motor's type (DC, BLDC, AC...).
You should also think about such things as current control, velocity and position control, any regulator (PID for example) for these. If velocity and position control may be not necessary, current control is obligatory.
Good luck!
dimas_lilik
Full Member level 2
You can use VNH2SP30 from STMicroelectronic
- Status
