Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Stovetop Toner Transfer

Status
Not open for further replies.

t0m

Junior Member level 1
Joined
Jul 26, 2012
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,374
I have been having good results with a new toner transfer technique. Put a heavy hotplate on the stove and dial in a temperature of 175 °C using a thermocouple. Bond the toner image to the copper clad board by placing them print side down onto the hotplate between two sheets of paper and applying pressure with a rolling pin for 2-5 minutes. For double sided boards, flip every 30 seconds or so.

http://smokedprojects.blogspot.com/2012/12/diy-pcbs-by-toner-transfer.html
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top