STM32L431 controller PA7 pin short to the GND

Status
Not open for further replies.
D

dhiraj.mahajan

Member level 1
Joined
May 29, 2017
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
265
Hello All,
Please help me product on filde work 2 month and return for fail, i am observe that controller PA7 pin short to Ground so help me that is problem to short controller pins
please reffre attached PDF file
 

Attachments

  • G&B Digimech Lock Control V4.0 17092018 Schematic PDF file.pdf
    103.2 KB · Views: 64
  • G&B Digimech Lock IR Sensor V2.0-27032018.pdf
    30.8 KB · Views: 116

Hi,

The signal goes to a connector ... then most presumably to an external circuit .... but without ESD protection.

Good design add ESD protection on every signal that leaves/enters the PCB.

It seems you need to replace the controller IC ... including firmware.

Klaus
 

thanks to replay
i am attached two Pdf that can be shower to connect control pcb to IR PCB used harness but this product work on filed 2 month and customer complaint then this condition is observed only one pin is damaged.
 

Can you confirm that PA7 shows a short to ground, that can be measured without powering the processor board and with J2 disconnected? How many ohms?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…