Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It depends on the car and the coil, there are so many kinds that you need to be more specific. The easiest way I spot is to measure the coil's resistance and use Ohm Law to determine the current, since the applied voltage in theory is 12Vdc.
I you think this helps, click on "helped me" for the statistics
Hi everybody,
Genearly, It's need above 4A.
But you must consider other such as voltage, energy.
It also depend on gap of spark plug.
I made it with above 4A, above 200V(in primary of ignition coil) and above 115mJ.
Please someone can give these data for Distributorless Ignition System?
I would like to known data for distributorless ignition.
Is it same as distributor type?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.