yefj
Advanced Member level 4
Hello ,I am try to communicate with INSTEK GSP-730 spectrum analizer which link photo shown bellow.
as you can see in the photo bellow i have sucseeded connecting to the device with all communivation parameters COM3 port ,baude rate 115200 etc..
I am trying to send the idn? command as was specified in the manual page 80.(to get basic responce from the device)
but the only way i see is to send it as a file.
A text file with a single word idn? was created but when i press send the file nothing happens.
Is the some alternative software i could use to communicate with the device?
where did i go wrong?
Thanks.
www.manualslib.com
as you can see in the photo bellow i have sucseeded connecting to the device with all communivation parameters COM3 port ,baude rate 115200 etc..
I am trying to send the idn? command as was specified in the manual page 80.(to get basic responce from the device)
but the only way i see is to send it as a file.
A text file with a single word idn? was created but when i press send the file nothing happens.
Is the some alternative software i could use to communicate with the device?
where did i go wrong?
Thanks.
![ibb.co](https://i.ibb.co/PYhRRn3/photo-spec.png)
Download GW Instek GSP-730 User Manual | ManualsLib
![www.manualslib.com](https://www.manualslib.com/favicon-32.png)
![ibb.co](https://i.ibb.co/wWRC5q3/photo-prog.png)