It makes it impossible for EAGLE to automatically generate GND connections, thus you spend more time to route them manually.
With your layout I don´t see a single GND connection that needs to be routed manually
Klaus
Why spend the time to route them manually,is this a contradiction? should i do it manually on not?
dis none top bot dim via pad unr tpla tnam
grid mil 25 2
group all
ch wi 24
// then right click with the mouse somewhere
rip gnd
// all your handmade GND connections are open
rip vcc
// all your handmade VCC connections are open
ch isol 24
// then left click with the mouse on the GND polygon (red dotted line)
// then left click with the mouse on the VCC polygon (blue dotted line)
rat
// now all VCC and GND connetions are made by EAGLE
dis -top -dim
mov (2550 2600) (3650 2600)
set wire_bend 1
split (3650 4000) (3200 1200) (3200 500);
rip 12V
ch orphans off
ch lay bot
set wire_bend 0
poly '12V' (2700 3650) (3575 1800) (2700 3650);
rat
i use external interrupt pin on atmega 8(INT1) to do action, but there is a relay and motor in my circuit which activated the interrupt and execute the action. i used switch debounce but no vain how to solve this problem?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?