sonar_abhi
Member level 1
Hello All,
I have been designing a solar charge controller for 12 volt battery. The circuit is shown below. The parameters of the buck converter are as follows:
D1: Schotkey diode MBR1645
L: 8uH
Ci: 470uF
Co: 2000uF
Can anybody please validate the above design. The parameters are as follows:
Vin(min): 15V
Vout: 12 V
Iout: 15 A
Switching Frequency: 50kHz
Iripple: 30%
Vripple: 10%
The 1kHz PWM wave feeds the Dickson Charge Pump for driving the gate of the IRF44Z.
I have been designing a solar charge controller for 12 volt battery. The circuit is shown below. The parameters of the buck converter are as follows:
D1: Schotkey diode MBR1645
L: 8uH
Ci: 470uF
Co: 2000uF
Can anybody please validate the above design. The parameters are as follows:
Vin(min): 15V
Vout: 12 V
Iout: 15 A
Switching Frequency: 50kHz
Iripple: 30%
Vripple: 10%
The 1kHz PWM wave feeds the Dickson Charge Pump for driving the gate of the IRF44Z.