Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Snubber circuit for contactor

Status
Not open for further replies.

vonskyes

Newbie level 1
Newbie level 1
Joined
Nov 6, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
1
Trophy points
1
Visit site
Activity points
7
I need to connect an RC-snubber circuit across the coil of a 20A 230V 50hz contactor (DILEM 10) in order to mitigate the effect of voltage transients due to inductive loads connected on the circuit. I need to specify the values of the resistor and capacitor to help me in selecting the right components.
Pls help!!!!!!!
 
A typical snubber circuit for such application comprises a 0.1 to 0.5 uF capacitor rated for >630 V AC, and a 5 to 100 Ohms resistor, 1...5 Watts. Exact values depend upon the load type, inductive loads generate larger transients and require larger caps and smaller resistors in the snubber circuit.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top