Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am not familiar with series chokes in power supplies, I've seen a low value series resistor before the capacitors to limit the inrush current.
If you get the datasheet for the MUR1560 and check the diode's ratings, then you can compare it with the power drawn by the expected/maximum load and check the peak impulse rating is much higher than you are expecting.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.