Hello, can anyone help me.
I have a rectifier as shown in attachment, and i want to make a matching circuit using smith chart utility . when i open it i got this problem. so please help me to solve it.
Did you design the matching circuit ?? There should be sub-circuit that has already been designed before in it.
You cannot use this block as you wish..You have to design a circuit then you can place it in another circuit.
Did you design the matching circuit ?? There should be sub-circuit that has already been designed before in it.
You cannot use this block as you wish..You have to design a circuit then you can place it in another circuit.
I mean have you ever designed the matching circuit by using Smith Chart Utility ?? If you have done, you should normally see the sub-circuit when you go into hierarchy down..
I mean have you ever designed the matching circuit by using Smith Chart Utility ?? If you have done, you should normally see the sub-circuit when you go into hierarchy down..