We are just womdering if the attached 72way header will be enough to support this PCB vertically?...(into the corresponding mating housing)
Whats the lowest contact number we can get away with here?.....electrically we only need some 12 contacts.
Its a 30W non-isol flyback SMPS with ETD29 transformer.
...Thanks, no its just the connector itself....good idea about having connectors either side......i may put in a 72way dual row footprint...then put a 20way either end on one side of the PCB....and a 20 way in the middle on the other side of the pcb....do you think that will suffice?.........then only solder the sockets in with the pcb inserted (so as to avoid solder hole position tolerances)
--- Updated ---
So, as such , we wonder if the attached will be ok?….its three dual row 20way headers …1 and 3 facing one way on the PCB …and 2 facing the other way…..what do you think?....enough stability for prototype?