Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

small programming connector for Atmel SAM3N00B microcontroller?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,

I am using the Atmel SAM3N00B microcontroller and the only way I can see to do in circuit serial programming is to use the 20 way JTAG connector.

However, this connector is too big for our production unit, and I wondered if there is a smaller, say 5 pin programming connector which I could use?


SAM3N DATASHEET:
http://www.atmel.com/Images/doc11011.pdf
 

Thanks Yophy,

The part number of the 20way JTAG connector is Molex 70246-2004.

I need whatever connector it is that is smaller than this, and yet still programs the SAM3N00B
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top