an_82
Member level 2
- Joined
- Oct 6, 2013
- Messages
- 52
- Helped
- 7
- Reputation
- 14
- Reaction score
- 7
- Trophy points
- 8
- Location
- Delft, Netherlands
- Activity points
- 303
I am simulating a trans-conductance circuit (OTA). I want to obtain pulse response of the circuit.
So I applied a square waveform voltage as the input, then I see the output current.
My question is that may I compare the output current waveform with input voltage and then calculate the slew rate or delay time ? or both of the signals should be the same?
Does the circuit in close or open loop form?
So I applied a square waveform voltage as the input, then I see the output current.
My question is that may I compare the output current waveform with input voltage and then calculate the slew rate or delay time ? or both of the signals should be the same?
Does the circuit in close or open loop form?
