sandeep_sggs
Full Member level 2
spartan 3 guide for mode
dear all,
m trying to configure spartan3-xc3s400-pq208 in slave serial mode using PC. I have " parallel cable III for xilinx"
I set the mode pins to 111 i.e slave serial. Then i open impact and give the bit file for programming the device.It shows programming successful and Done pin goes high, but the desired functionality is not achieved.(m tring for the half adder just for experiment)......when i do same thing using same files in JTAG mode the programming is successful and the desired functionality is achieved......
m not able to locate the fault in my process........
can anybody help me...
dear all,
m trying to configure spartan3-xc3s400-pq208 in slave serial mode using PC. I have " parallel cable III for xilinx"
I set the mode pins to 111 i.e slave serial. Then i open impact and give the bit file for programming the device.It shows programming successful and Done pin goes high, but the desired functionality is not achieved.(m tring for the half adder just for experiment)......when i do same thing using same files in JTAG mode the programming is successful and the desired functionality is achieved......
m not able to locate the fault in my process........
can anybody help me...