Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Single Pahse Matrix Converter Design

Status
Not open for further replies.
A

adnan012

Advanced Member level 1
Advanced Member level 1
Joined
Oct 6, 2006
Messages
468
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
4,923
Single Phase Matrix Converter Design

hi,

I want to implement a single phase matrix converter as shown in the attached file.
I want to implement buck topology . I am confused about the implementation PI control.I want to generate PWM using PIC micro controller. And for PI i want to use op amp based circuitry .ADC will read the value of PI .Is it possible to do that?
 

Attachments

  • Modeling and Simulation of a Single Phase Matrix Converter with Reduce Switch Count as a BuckBo.pdf
    183.1 KB · Views: 65
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top