simulation warning message in ADS! PLS HELP!

Status
Not open for further replies.
M

modelstudent

Newbie level 6
Joined
Aug 12, 2010
Messages
14
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,370
I am designing a multi band antenna and i use ADS to simulate it, i have some warning message when it simulating the S-parameters:
inaccuate (high frequency ) calibration;
electrically large via using lumped model;
higher order modes at the ports;
grouped strip-slot ports;
mesh density is too coarse;



can anyone tell me why did this happen??
thanks!!!
 

i think you need calibration again... Maybe you have to calibrate and increase distance frequency
 

i am using a partial ground plane for my antenna ( using layer cond2)
should i place a port on layer cond2 to ground it?
or only one port on layer cond for input is enough?
 

I met the same warning. Can someone offer more explanations on how to handle this?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…