simulating the "Stripline parallel-coupled lines filter" on Advanced Design System
How can I draw the microstrip parallel-coupled lines in ADS (the file be attached in this post, shows the structure). In fact, these lines with unequal length, offset beginning position and desired angle are used frequently for designing the band-pass filters. suggested structure must be considered the coupling effect between lines.
thank you. but imported file cannot consider the coupling effect. in addition, how can I use the imported file in schematic design (maybe those file are useful in momentum but how about optimization and ...)
---------- Post added at 12:23 ---------- Previous post was at 12:18 ----------