simulate radial stub using ADS2003

Status
Not open for further replies.
S

spide

Member level 3
Joined
Nov 29, 2004
Messages
61
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
412
sprameter

i am not sure about how to simulate(s-parameter) radial stub using ADS2003.how to interpret s-parameter for radial stub.i am working on 2.4GHz.the radial stub is used together with the high impedance line(biasing transistor).could anyone help.
 

simply place the radial stub amd the TL of high impedance with it
place a sprameter controller and a termination

just it

wish this help

khouly
 

what is the theoritical expected s-paramater should look like.
 

i think the expected s parameters will be like loss passfilter , coz the radial stub acts as shut capacitor to ground , and the high impedance line act as inductance "RFC"

this structure is always used to feed the DC voltage to the active device and eleminate any RF signal from pentrating to DC circuit ,

which this help

khouly
 

is this the correct result.could u pls futher comment ragarding the S11 and S21.
 

can u plz post a schematic diagram of the circuit u simulated

and tell me what kind of substarete u use

khouly
 

This is my setup. I think that is a correct result since it block RF at desired frequency.
 

same with me.but i am not sure whether my observation of s-parameter is correct
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…