huydai2004
Newbie
Hi everyone.
Now I am learning about the A7677S-MANV module. And I have a question.
When I supply an external voltage (1.8v) to the GNSS_VBKP. I close the GNSS part and then I active it via AT command.
The data in the "ZDA sentence" is reset to the "$GNZDA,,,,,00,00*56".
please tell me how to keep this data in the GPS part when I close GNSS through the AT command, or when I Power off the A7677S-MANV module.
if possible please send me the information about this module by posting it here.
Regards!
Dai Ho Huy
Now I am learning about the A7677S-MANV module. And I have a question.
When I supply an external voltage (1.8v) to the GNSS_VBKP. I close the GNSS part and then I active it via AT command.
The data in the "ZDA sentence" is reset to the "$GNZDA,,,,,00,00*56".
please tell me how to keep this data in the GPS part when I close GNSS through the AT command, or when I Power off the A7677S-MANV module.
if possible please send me the information about this module by posting it here.
Regards!
Dai Ho Huy
Last edited by a moderator: