Signalyzer
Newbie level 3
signalyzer jtag
Hi All,
I would like to introduce a new product:
Signalyzer is a small but very versatile and flexible dual channel multifunctional and multi-protocol device.
Dual channel design provides two channels which can be individually configured. Whether you need JTAG Boundary-Scan interface to program and debug your design or your project requires control of SPI or I2C bus or even you need UART or simply toggle I/O lines at logic levels of your design. All of these tasks can easily be accomplished with Signalyzer tool.
Flexible API and Open Source development further extends the capabilities of device allowing you to customize the functionality or even develop your own applications using broad range of development tools for Linux and Windows environments.
Capabilities:
- 2 Channel
- SPI bus host controller
- On-Chip Debugging (OCD) via OpenOCD
- I2C bus host controller
- In-system Programming (ISP)
- UART
- Boundary Scan Testing (JTAG)
- 8bit - flexible GPIO
- Support for other serial protocols
Features:
- USB2.0 - Full-speed, 12Mbits/sec
- USB powered
- JTAG / IEEE 1149.1 compatible
- Supports: JTAG, I2C, SPI, UART and 8 bit GPIO interfaces
- Based on FTDI FT2232C/L device
- Two independent channels with own Vext supplies
- I/O signals are compatible across 1.2V - 5.5V signal range with ext. Vref
- All I/O lines are ESD protected
- All I/O lines are short-circuit protected
- Over-voltage and over-current protection on Vext supplies
- Programmable baud rate up-to 6Mbits/sec
- Free drivers for Linux, Windows XP, 2000, 2003, CE platforms
- Open source debugger support
- API to allow to further extend capabilities
For additional information please visit our site: www.signalyzer.com
Best regards to you all!
Hi All,
I would like to introduce a new product:
Signalyzer is a small but very versatile and flexible dual channel multifunctional and multi-protocol device.
Dual channel design provides two channels which can be individually configured. Whether you need JTAG Boundary-Scan interface to program and debug your design or your project requires control of SPI or I2C bus or even you need UART or simply toggle I/O lines at logic levels of your design. All of these tasks can easily be accomplished with Signalyzer tool.
Flexible API and Open Source development further extends the capabilities of device allowing you to customize the functionality or even develop your own applications using broad range of development tools for Linux and Windows environments.
Capabilities:
- 2 Channel
- SPI bus host controller
- On-Chip Debugging (OCD) via OpenOCD
- I2C bus host controller
- In-system Programming (ISP)
- UART
- Boundary Scan Testing (JTAG)
- 8bit - flexible GPIO
- Support for other serial protocols
Features:
- USB2.0 - Full-speed, 12Mbits/sec
- USB powered
- JTAG / IEEE 1149.1 compatible
- Supports: JTAG, I2C, SPI, UART and 8 bit GPIO interfaces
- Based on FTDI FT2232C/L device
- Two independent channels with own Vext supplies
- I/O signals are compatible across 1.2V - 5.5V signal range with ext. Vref
- All I/O lines are ESD protected
- All I/O lines are short-circuit protected
- Over-voltage and over-current protection on Vext supplies
- Programmable baud rate up-to 6Mbits/sec
- Free drivers for Linux, Windows XP, 2000, 2003, CE platforms
- Open source debugger support
- API to allow to further extend capabilities
For additional information please visit our site: www.signalyzer.com
Best regards to you all!