Dec 10, 2012 #1 R razsab Newbie level 5 Joined Nov 27, 2012 Messages 10 Helped 0 Reputation 0 Reaction score 0 Trophy points 1,281 Activity points 1,340 hi for all , after I wan't generate signal square with pic 16F877A with 2 Mhz frequency i want the diagram cabling with isis and the code with the mikroc
hi for all , after I wan't generate signal square with pic 16F877A with 2 Mhz frequency i want the diagram cabling with isis and the code with the mikroc
Dec 10, 2012 #2 Tahmid Advanced Member level 6 Joined Jun 17, 2008 Messages 4,756 Helped 1,798 Reputation 3,588 Reaction score 1,656 Trophy points 1,413 Location Berkeley, California Activity points 30,586 You can use the compare or PWM section of the CCP module. You mentioned a frequency of 2MHz? Is this the required output frequency or the frequency at which the PIC runs. For operation with CCP module (with code), check here: https://www.edaboard.com/blog/1820/ Hope this helps. Tahmid.
You can use the compare or PWM section of the CCP module. You mentioned a frequency of 2MHz? Is this the required output frequency or the frequency at which the PIC runs. For operation with CCP module (with code), check here: https://www.edaboard.com/blog/1820/ Hope this helps. Tahmid.