Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

siemens at commands.

Status
Not open for further replies.

dio123

Newbie level 1
Joined
Jun 28, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
lisbon
Activity points
1,289
Good afternoon,
I have a project to send messages with arduino, but the mobile phone siemens c45 died. I bought a siemens c62 ..

Now I did some tests with the hyperterminal with arduino but without the atmega inserted and can run several commands such as atd12045 read and send messages.

Happens that when connected with ATMEGA328 can send commands to it, but when I read a message appears in hyperterminal: Te% Õ? * Ÿ? Having ¥% ¥? Ê. But it must seem 6697DB6F7B990D ....

Have told me it could be baud rate, tried changing but always gives error.
AT + IPR =? result error
AT + IPR = error result 9600
Error result AT & W
at + baud5 result error

grateful for your help.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top