Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Set UC2825 up for current mode Full Bridge?

Status
Not open for further replies.

cupoftea

Advanced Member level 5
Joined
Jun 13, 2021
Messages
2,607
Helped
54
Reputation
108
Reaction score
115
Trophy points
63
Activity points
13,666
Hi,
We do Full bridge 220vin 250khz, 500wout, 28vout

Do you agree, for current mode control, the CST output ramp should be connected to both the RAMP pin and the ILIM pin.?
We have been given a circuit and the current sense voltage gets divided down, then fed to the ILIM pin, ..when the CS voltage has already been fed to the RAMP pin.
It doesnt seem to make sense, though im just wondering if im havign a brain trip-out?

UC1825
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top