Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Set GPIO using EMAC (LPC1768 )

Status
Not open for further replies.
P

Prakash Rajolli

Newbie level 6
Joined
Jul 16, 2010
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Bangalore
Activity points
1,416
Hello,

I am very new to EMAC. I have chosen the controller LPC1768 which have
inbuilt Ethernet MAC.

I am trying to write firmware to operate some leds connected to LPC1768
Board using EMAC protocol.i.e Ethernet cable is connected between
LPC1768 Board and Laptop, make led on/off by laptop through EMAC.

It would be great if somebody give thoughts on it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top