Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

send with PT2262 and read with PIC16F628

Status
Not open for further replies.

turkbey

Newbie level 4
Joined
Sep 2, 2007
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,327
pt2262 exampel

Hello dear friends.
I want to make a new project but, have some unknown.
I have a transmitter module 433,92 Mhz rf module and PT2262 encoder I send any data and adress word. than I want to use rf receiwer modules 433,92 and PIC16F628 for decoding.
So how can I read from PT2262 IC's datas whith PIC16F628
Thanks for all
 

andre_teprom

Super Moderator
Staff member
Joined
Nov 7, 2006
Messages
9,252
Helped
1,151
Reputation
2,321
Reaction score
1,133
Trophy points
1,403
Location
Brazil
Activity points
53,872
pic16f628,433,92

I used it, a long time ago.

You could eliminate this IC, and send data directly by a power RF transistor. But, if you want use it IC, you could do it like I did :

Use the last 4 bit's of adress of PT2262 to send the nibbles of each byte, half-byte to half-byte, each time you send data.

At Receiver side, the IC must be the PT2262-M4/L4, because it part ( ....M4/L4 ) decode 4 data bits. So, in order to improve data security, due enviroment may contain noise, I sent a character marker between each data. In case, I used the 0xC ( 1010b )

In case, I used BCD codification ( data range : 0....9 ). So if I wont send for example a character sequence 'A','B','C', for example, I had to send :

Code:
0100 1010 0001 1010 0100 1010 0010 1010 0100 1010 0011
  4      C     1        C     4      C     2       C      4      C     3
Due :

Code:
0100 0001 = 'A' = 0x41
0100 0010 = 'B' = 0x42
0100 0011 = 'C' = 0x45

It worked very well, but I used an integrity algoritym to verify integrity of received data.


+++
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top