Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SAR (Specfic Absorbtion Rate) settings in HFSS 15

Status
Not open for further replies.

kannangk1990

Newbie level 4
Newbie level 4
Joined
Jan 7, 2015
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Tirupur,Tamilnadu, India
Visit site
Activity points
49
Hello all,

I am new to HFSS and I am not familiar with the settings I have to do for SAR measurement. I have finished my surface coil design and got the S-parameter now I need to use the frequency of 63.87 MHz as the solution frequency to obtain the SAR inside a phantom which I have placed above the radiating coil. I have given the phantom the properties of Skin(conductivity, permitivity etc).

If I simulate with this settings I'm getting error as "Average SAR calculation with invalid tissues, please check your SAR settings".

I want to know the procedure to measure the SAR.

I do have the HFSS v10 book but in that only E-field measurement is there. Can anyone please help me with this issue.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top