dazhiruoyu
Newbie level 2
I am using CST to simulate microwave heating response of tissue using coax cable. I assign density to materials in order to calculate SAR. But the transient solver will stop at Transient Analysis, Pass 1, Raster=1.000, and never respond.
When I restart CST, I could see the simulation results.
But if I set the density of materials to 0, the simulation runs pretty fast. But I can't calculate SAR.
Anyone know why does this happen?
Thanks!
When I restart CST, I could see the simulation results.
But if I set the density of materials to 0, the simulation runs pretty fast. But I can't calculate SAR.
Anyone know why does this happen?
Thanks!