Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Samsung XE700T1A Digitizer pinout

Status
Not open for further replies.
D

d_a_l_3

Junior Member level 1
Joined
Jun 8, 2007
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Croatia
Activity points
1,387
Hi all

I got one spare digitizer and wanted to corvert to usable touch board but don't have pinouts, this is scanned picture
PinOut.png

picture is small but this is all I can zoom
lightshot.png

I know that this 2 connected from left can be GND but rest is problem, it is capacitive so it have to be i2C or SPI
Also on board there is 3 serial MXT154 (small one) and one big (controller) MXT1386-u

if someone know how to identify pins I would be very thankful

P.S.
If is wrong forume remove to right one, didn't know were to post
Thx
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top