teemaciba
Newbie level 4
s parameter in schematic is different from 1D s parameter
I'm pretty new to CST, so this might be a silly question.
I'm building a double loop RF coil. I noticed that in the schematic view, my s parameter task was giving a very different result than the s parameter in the 1D results in 3D view. So when I tune my capacitors using the schematic s parameter, I end up getting a totally different results in the 1D s parameter results.
I don't understand what the difference between them, and which one should I be looking at?
Help please.
Thank you
I'm pretty new to CST, so this might be a silly question.
I'm building a double loop RF coil. I noticed that in the schematic view, my s parameter task was giving a very different result than the s parameter in the 1D results in 3D view. So when I tune my capacitors using the schematic s parameter, I end up getting a totally different results in the 1D s parameter results.
I don't understand what the difference between them, and which one should I be looking at?
Help please.
Thank you
Last edited: