T
Most serial communication interface programs ( actually all of them, AFAIK ) supports capturing received data to file, so you could selecct anyone. The Hiperterminal - which is no longer available on Windows package - is one which has this feature, but you would be succedded just for standard ASCII characters ( alphabetical, mumerals and symbols ), not for control characters. For Windows there is the Realterm, a nice tool.He says we will also need a “serial data to file” program, and he says he uses “coolterm, so i guess we have to buy/download that?
Our remote software engineer wants us to run some debug code
Do we need to set up MPLAB IPE in debug mode or something?
Please could i ask how to use Realterm serial data acquisition program?
We want to load the debug output of our microcontroller to a file but we are not sure how to do this.
He says we should connect up to pin 14 (TX) and gnd at the micro.
...and youve no way of knowig which port the data is coming in on.
sometimes it works and sometimes it doesnt.......recently we spent two hours trying to get the data to save into a file...then all we did was change to a file in a different folder and it was ok again.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?