iamyuchenjie
Junior Member level 1
Hi everyone
I find it is too slow in my system to run SimVision
： ncsim +access+wrc -f run.f +gui
The project is not very large.
It sometimes use more than 2 minutes to start the GUI.
Is there anyone has the similar experience?
My system is RHEL4 VM. And my NCsim is ldv5
Thank you all
- - - Updated - - -
And another question is that: when I have already run a simulation, and then I want to modified my tb. In this case, do I have to close all the current simulation windows? And re-run:
ncsim +access+wrc -f run.f +gui
Or ,is there any time-saving way suggested?
Thank you very much
I find it is too slow in my system to run SimVision
： ncsim +access+wrc -f run.f +gui
The project is not very large.
It sometimes use more than 2 minutes to start the GUI.
Is there anyone has the similar experience?
My system is RHEL4 VM. And my NCsim is ldv5
Thank you all
- - - Updated - - -
And another question is that: when I have already run a simulation, and then I want to modified my tb. In this case, do I have to close all the current simulation windows? And re-run:
ncsim +access+wrc -f run.f +gui
Or ,is there any time-saving way suggested?
Thank you very much