gray1st
Newbie level 1
Hi
I am looking at a project in which a microcontroller (Pic), receives data from a device via RS232, a check is then done by the microcontroller to see if the data value recieved is higher than a stored variable (i.e. initially set to 0, but as data is recieved is replaced by the highest value), if it is higher it is passed out via the RS232 output.
I am very very new to microcontrollers and PCB's, can someone please advise me of the best way to go about this?? Including and Pic programming code that you could help with?
I am looking at a project in which a microcontroller (Pic), receives data from a device via RS232, a check is then done by the microcontroller to see if the data value recieved is higher than a stored variable (i.e. initially set to 0, but as data is recieved is replaced by the highest value), if it is higher it is passed out via the RS232 output.
I am very very new to microcontrollers and PCB's, can someone please advise me of the best way to go about this?? Including and Pic programming code that you could help with?