Command RN42 Bluetooth module
Hi,
I have just connected the RN42 BT module as a Master with HC06 BT module (as a slave), everything works properly so far. The command I am using in order to pair both BT modules is ( C,<address> ), however, now I would like to go a step further connecting them as the following way:
Master module will check if there is any MAC address available, if so, read the MAC address, and then, I will connect them as the same way than I usually do (C,<address>).
Could anybody help me with the command mode in order to check the available MAC address, since I was no able to find out which command could fit properly for it,please?
Many thanks