Mix_me
Newbie level 2
Hi all,
I am doing a speical design which requires to include contact resistance in the simulation. If I set rgeoMod=4 which both end-source and end-drain contact would be point contact. How do I input contact resistance value in the simulation through model card or simulator.
I am using nanospice.
Thanks
M
I am doing a speical design which requires to include contact resistance in the simulation. If I set rgeoMod=4 which both end-source and end-drain contact would be point contact. How do I input contact resistance value in the simulation through model card or simulator.
I am using nanospice.
Thanks
M